Ignition Tune Up Kit Fits John Deere Replaces 1900119

One New Aftermarket Ignition Tune Up Kit

Tech Info:
-Kit Contains
-(1) Spark Plug Wiring Set
-90 Degree Boots
-Wires Are Approximately 32″ and 49″ Long
-Copper Core
-Aluminum Coating to Prevent Corrosion
-Neoprene Outer Cover
-Each Spark Plug Wire Has One End Pre-Assembled – Crimp the Other End With a Crimping Tool
-Coil Wire is the Excess Wire Left Over From the Spark Plug Wire
–
-(1) Distributor Cap
-Dim A (1) 2 Cyl. Vertical
-Dim B (2) Clip Type
–
-(1) Spark Plug
-7/8″ – 18 Thread Diameter
-5/8″ Reach
-15/16″ Hex
-Cold Heat Range
-Standard Tip / Non-Resistor
-Replaces Part Number: AL3076
–
-(1) Tune-Up Kit
-Contains: Breaker Points, Condenser, and Rotor.
-Replaces Part Number: ATK1DCR
–
-(1) Distributor Dust Cover
-Includes Felt gasket, Washer, Ruber seal
–
-Please Note: Fits Delco Distributors with Clip-On Cap Only
-Replaces Part Number: 1900119
–
-(1) Engine Oil Filter
-4-1/8″ Length
-3-5/16″ O.D.
-1.095″ Center Stud Hole Diameter
-Cartridge Type Filter
-Replaces Part Number(s): ABC217, AH1081R, AH812R
–
-(1) Sediment Bowl Assembly
-3/8″ Pipe Thread
-1-1/4″ Long Bowl
–
-DOES NOT INCLUDE FUEL LINE ADAPTOR
-Replaces Part Number(s): AM3100T, AT326991

Made to Fit John Deere:
Industrial/Construction Models: 8820, 8825, 8825HP, 8830, 8840, 8850
Model Breaks: 8820 (Gas & Diesel), 8830 (Gas & Diesel)
Replaces Part Number(s): AM3100T, AT326991

Replaces Part Number(s): AL3076, 1900119, ABC217, AH1081R, AH812R
Additional Information: Kit Contains(1) Spark Plug Wiring Set90 Degree BootsWires Are Approximately 32″ and 49″ LongCopper CoreAluminum Coating to Prevent CorrosionNeoprene Outer CoverEach Spark Plug Wire Has One End Pre-Assembled – Crimp the Other End With a Crimping ToolCoil Wire is the Excess Wire Left Over From the Spark Plug Wire(1) Distributor CapDim A (1) 2 Cyl. VerticalDim B (2) Clip Type(1) Spark Plug7/8″ – 18 Thread Diameter5/8″ Reach15/16″ HexCold Heat RangeStandard Tip / Non-ResistorReplaces Part Number: AL3076(1) Tune-Up KitContains: Breaker Points, Condenser, and Rotor.Replaces Part Number: ATK1DCR(1) Distributor Dust CoverIncludes Felt gasket, Washer, Ruber sealPlease Note: Fits Delco Distributors with Clip-On Cap OnlyReplaces Part Number: 1900119(1) Engine Oil Filter4-1/8″ Length3-5/16″ O.D.1.095″ Center Stud Hole DiameterCartridge Type FilterReplaces Part Number(s): ABC217, AH1081R, AH812R(1) Sediment Bowl Assembly3/8″ Pipe Thread1-1/4″ Long BowlDOES NOT INCLUDE FUEL LINE ADAPTORReplaces Part Number(s): AM3100T, AT326991